76
EMC Host Connectivity with Emulex FC HBAs and FCoE CNAs for the Linux Environment
Installing and Configuring the Linux Host with the Emulex Driver
Creating symlink /var/lib/dkms/lpfcdfc/1.0.13/source ->
/usr/src/lpfcdfc-1.0.13
DKMS: add Completed.
Preparing kernel 2.4.21-27.0.1.ELsmp for module build:
(This is not compiling a kernel, only just preparing kernel symbols)
Storing current .config to be restored when complete
Running Red Hat style preparation routine
make clean....
using
/lib/modules/2.4.21-27.0.1.ELsmp/build/configs/kernel-2.4.21-i686-smp.config
make oldconfig.....
running dkms_mkkerneldoth....
Building module:
cleaning build area....
make KERNELRELEASE=2.4.21-27.0.1.ELsmp INC_TOP=/usr/src/lpfc-7.1.14......
cleaning build area....
DKMS: build Completed.
Running module version sanity check.
lpfcdfc.o:
- Original module
- No original module exists within this kernel
- Installation
- Installing to /lib/modules/2.4.21-27.0.1.ELsmp/kernel/drivers/scsi/lpfc/
depmod....
DKMS: install Completed.
* Done : Step 1: The ioctl module has been compiled and installed under
/lib/modules
************************************************************
* The Emulex DFC module has been installed on your system. *
************************************************************
5. Use the DKMS command to verify that the drivers have been
built and installed successfully.
For example:
[root@l82bi250 /]# dkms status
lpfc, 7.1.14, 2.4.21-27.0.1.ELsmp, i686: installed (original_module exists)
lpfcdfc, 1.0.13, 2.4.21-27.0.1.ELsmp, i686: installed
6. Reboot the host.
Caveat
If the
lpfcdfc driver is loaded, then it must be unloaded prior to the
lpfc driver.
Comments to this Manuals