Emulex 375 User Manual download pdf (Page 55)

EMULEX MODEL 375 SAN STORAGE SWITCH

USER’S GUIDE CHAPTER 3: SWITCH MANAGEMENT

EMULEX CORPORATION 52

ART NUMBER 00041369-002 REV. B

Port Utilization and Health

Port utilization measures the amount of traffic passing into a port over a period of time. For example, if

an initiator is transmitting data to a target, the initiator port displays a port utilization value (%) while the

target port does not. If the same initiator is receiving data from the target, the target port displays a port

utilization value (%) while the initiator port displays does not.

This part of the Web page displays each port number, the port’s current health status, and a vertical bar

indicating the port utilization.

A port number is displayed in one of three colors depending on the port’s current health:

Port utilization is measured by a vertical bar that moves upwards as utilization increases. The vertical

bar has the three distinct levels of utilization:

Tip: Rolling the mouse cursor over the port number displays the current port state.

Port Color Indication

Green An SFP is inserted into the port and a device is connected to the SFP.

Yellow • Bypassed – The port is bypassed. An SFP may be inserted in the port but

there may not be a device connected to the SFP.

• Loopback – There is no device connected to the port. The transmit and

receiver are connected together on the SFP transceiver.

• LIPF8Present – If the switch is receiving an F8 Failure notification, the

port is bypassed to allow remaining devices to proceed with initialization.

• Redundant – The port is a failover link in a cascade and is not currently

active.

Red • TxFault – Detects an SFP transmitter fault.

• DiagTx – Detects Ordered Sets being transmitted, so traffic cannot be

passed through the port.

• DataTimeout – Detects a data timeout fault.

• RxLoss – Detects a loss of received signal amplitude from the device.

• SyncLoss – Detects a loss of word synchronization for a specified time,

which may be caused by poor signal strength, intermittent line conditions,

and so on.

Gray • Unknown – The port status cannot be determined.

• NoSFP – There is no SFP connector inserted in the port.

Bar Color Indication

Green The port is operating at optimal utilization.

Yellow The port is experiencing periods of heavy traffic.

Red The port has too much traffic on it and is not operating at desired levels.

Some devices should be transferred to other ports to improve port

utilization.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 77 78

No comments

Emulex 375 User Manual Page 55