Emulex 375 User Manual download pdf (Page 29)

EMULEX MODEL 375 SAN STORAGE SWITCH

USER’S GUIDE CHAPTER 3: SWITCH MANAGEMENT

EMULEX CORPORATION 26

ART NUMBER 00041369-002 REV. B

Setting SNMP Traps

Simple Network Management Protocol (SNMP) uses traps to transmit information to SNMP-based

network administration programs. The Switch SNMP Trap Configuration page displays information on

the switch’s current SNMP trap configuration.

To view the SNMP trap configuration page, click Switch > SNMP Traps.

To configure an SNMP trap:

1. Enter the Trap IP address for the device to which the trap information will be sent.

2. Enter the Trap Port number.

This value is usually set to "162" for Windows and Apple-based networks.

3. Select the State.

4. Click Submit.

When editing a registered IP address, delete the current IP address and create a new entry for the

revised IP address.

State Description

Active The trap sends messages to the host identified in the IP Address

selection.

Inactive The trap is not operational.

Delete The trap will be deleted from the table once changes are saved.

Figure 3-4: Switch SNMP Trap Configuration page

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 77 78

No comments

Emulex 375 User Manual Page 29