Emulex LP9802DC User Manual download pdf (Page 33)

Driver for HP-UX - Troubleshooting Section Page 30

HP-UX-Specific Errors (100 - 109)

General HP-UX error codes range from 100 to 109. HP-UX FCP-specific error codes range from 100 to

139.

lpfcN: 100 : Attach failure: XXXXX

DESCRIPTION:The driver attach routine failed for reason XXXXX. The assigned DIP and attach routine

cmd are recorded.

LOG: ERROR always fcHPUX.c

ACTION: This error could indicate a software driver or firmware problem. If the problems persist, report

these errors to Technical Support.

lpfcN: 101 : Detach failure: XXXXX

DESCRIPTION: The driver detach routine failed for reason XXXXX. The assigned DIP and attach

routine cmd are recorded.

LOG: ERROR always fcHPUX.c

ACTION: This error could indicate a software driver or firmware problem. If the problems persist, report

these errors to Technical Support.

lpfcN: 102 : Config error: XXXXX

DESCRIPTION: Parameter XXXXX in the driver conf file has a bad value. The bad value and new value

are recorded.

LOG: ERROR always fcHPUX.c

ACTION: Check the driver .conf file, usually located in /opt/lpfc/conf/adapCfg.h

lpfcN: 103 : fc_malloc: XXXXX

DESCRIPTION: The driver memory allocation routine failed for reason XXXXX. Various memory

allocation parameters are recorded.

LOG: ERROR always fcHPUX.c

ACTION: This error could indicate a software driver or firmware problem. If the problems persist report,

these errors to Technical Support.

lpfcN: 104 : fc_bufmap: XXXXX

DESCRIPTION: The driver memory mapping routine failed for reason XXXXX. Various memory mapping

parameters are recorded.

LOG: ERROR always fcHPUX.c

ACTION: This error could indicate a software driver or firmware problem. If the problems persist, report

these errors to Technical Support.

1 2 ... 28 29 30 31 32 33 34 35

No comments

Emulex LP9802DC User Manual Page 33